Double Cone Rotary Vacuum Dryer is our new generation drying device combined with technology developed similar products, Cone Vacuum using a chain two resilient connections, hence equipment running smoothly. Specially designed technology, fully reflects the good two concentric shafts, thermal coal and vacuum systems are using a reliable mechanical seals or rotating joint US technology. Double cone rotary vacuum dryer works: through the sealed jacket heat source (for example, low pressure steam or thermal oil), heat is passed through the inner shell is dried material. Under driving of power, the tank is rotated slowly S continuously mixing tank material, so as to achieve the purpose of reinforced drying. Material in a vacuum, steam pressure drops to a moisture (solvent) saturated material surface and evaporated by vacuum timely discharge recovery. Material inner moisture (solvent) continuously to the surface of the infiltration, evaporation, discharge, three ongoing process, the purpose of drying the material in a very short time. Double cone rotary vacuum dryer studio no proof, anti-corrosion, and may not put Yi Ran, explosive, corrosive gas and dried goods. Double cone rotary vacuum dryer should be relative humidity ≤85% RH, non-corrosive gas around a vacuum dryer, no strong vibration source and the presence of a strong electromagnetic field environment. Items such as wet, then between the vacuum tank and the vacuum pump is preferably added filters to prevent moist gas into the vacuum pump, causing pump failure. After the double cone rotary vacuum dryer after repeated use, it will produce the phenomenon can not be evacuated, it should replace the door seal or adjust the door on the box buckle Reach to resolve. When the vacuum tank double cone rotary vacuum dryer temperature higher than 200 ℃, will produce a slow air leaks (except 6050,6050B, 6051,6053 outside), then open the back cover box with double cone rotary vacuum dryer Allen wrench to loosen the heater base, replace seals or tightening the heater base to solve. Double cone rotary vacuum dryer vacuum pump can not work a long time, so when the vacuum reaches double cone rotary vacuum dryer article claims, should be closed vacuum valve, then close the pump power until the vacuum is less than double cone rotary vacuum dryer requested items When, then open the vacuum valve and pump power, continue to vacuum, so to extend the pump life. Bleed valve rubber cap if the rotation difficult, including a generous amount can be greased. (Such as Vaseline). In addition to maintenance, but can not open the box on the left cover (except 6090 and 6210) in order to avoid damage to the electrical control system. Double cone rotary vacuum dryer should be kept clean. Door glass should not have reacted with a chemical solution to clean, use soft cotton cloth. If not long double cone rotary vacuum dryer, the exposed plating pieces painted neutral after wiping grease to prevent corrosion, and wear a dust cover plastic film, placed in double cone rotary vacuum dryer in the room, electrical components to avoid damage from moisture, affect the use. 

keywords: Kai Ruisi machine, double cone rotary vacuum dryer, vacuum dryer,